DIY Oil Change Tips and How To

Purolator Oil Filter ReviewHey everyone. A few weeks ago I did a video about changing your own oil. The response has been huge. Because of the response, I thought I would follow up that video and write a little more information about changing your own oil.

Changing your cars oil is one of the easiest things to do yourself. That being said, a mistake here can be very costly. An oil change is one of the most important things you can do to keep your car’s engine happy. Be sure to follow the manufacturers recommended service interval. So before you dive into changing your own oil, let’s talk about some do’s and don’ts.


  • Have a basic understanding of your car
  • Proper hand tools for your car
  • Have all the parts you need for the service. We will talk more about this later
  • Have a proper container to catch the oil
  • Be sure to have something to store the old oil.
  • Properly dispose of the oil, oil and filter.
  • Keep a record of the service


  • Be in a hurry
  • Cheap out of your parts
  • Forget to work safe
  • Put engine oil in the trash.

As you can see, there are plenty of things to keep in mind when doing your own oil change. Before we get into the steps to change your oil, let’s make sure we have all the right stuff.

It should come as no surprise, having the right oil, filter and washer is VITAL! You do not want to be the person that has to duct tape their oil filter back on. Yes, I have seen that happen. I talked a little about the differences in oil filters in the Purolator Review Post. Check that out for some filter features to consider. When it comes to oil, follow the manufacturer spec to the letter.  If you are not 100% sure about the oil you need, call your dealership’s parts department. They can tell you exactly what you need, and how much oil your car requires.

This will be highly vehicle specific. While I can’t list every tool to change oil, here are the parts you will need tools for:

  • Engine oil filter
  • Drain plug
  • Check your car for any cover that need to be removed. This may require more tools
  • Tools to remove the washer on the drain plug.
  • A funnel to add oil
  • Rags or towels for clean up
  • Drain bucket to collect oil
  • Your application may require some other special tools, especially if you drive a German car 😉

The Process
When I change oil, I have a very strict process I follow. It really is borderline OCD. You do not need to have such a strict process, but having a game plan is really important. Doing an oil change is also an opportunity to check the overall heath of your car. Here is my process for changing oil:

Damaged oil drain plug

Bad practices lead to destroyed oil pans

  1. Be sure you have ALL the parts to do the service. We don’t want to have to run out to the store during the service.
  2. Check the engine oil on level ground before you start.
  3. Raise the front of the car up. If you are using a floor jack, be sure to safely secure the car with jack stands. At home, I prefer the drive-on style ramps.
  4. Place the drain pan under the engine. Depending on how hot the engine is, the oil may “shoot out”. Be sure to place the pan accordingly. Also have your towels ready for any oil spills
  5. Allow the engine oil to drain for about 10 minutes. This will get most of the engine oil out. Remember, we are not in a hurry.
  6. Replace the washer on the drain plug, and properly tighten the drain plug.
  7. Remove the engine oil filter. Allow the oil to drain out of the filter.
  8. Before replacing the filter, put a thin film of oil on the filter.
  9. Properly tighten the filter.
  10. Replace any cover that you may had to remove.
  11. Lower your car on to level ground.
  12. Fill the engine with the recommended amount of engine oil.
  13. Double check the engine oil on the dipstick.
  14. Triple check the engine oil on the dipstick
  15. Start your car and let it run for about a minute.
  16. Shut the car off, and let it rest for 2-3 minutes.
  17. Recheck the engine oil level, and adjust as needed.
  18. Check and top off the coolant, power steering fluid, washer fluid, and transmission fluid(if applicable)
  19. Double check your work. Make sure there are no oil leaks!
  20. Record the service
  21. Be sure to properly dispose of the engine oil.

Well, congratulations, you have just crushed your own oil change. You might be thinking that 21 steps is a lot of work. But with the right tools, the right parts, and a little know how, you can to it. I really do want to stress buying top quality parts.

If you have any question about changing your oil, please post it up in the comments. You can also learn more about the history of the engine oil filter here.

I was paid by Purolator to review for this post with Burst Media, all thoughts and opinions are my own. All products were provided by Purolator; however are items I genuinely enjoy and feel are appropriate for my site.

10 replies
  1. Pat ~ The Muscle Car Guy
    Pat ~ The Muscle Car Guy says:

    Nice write up. I would add, if you haven’t used ramps before, make sure you have someone that can help watch the vehicle when you drive up on them so you don’t go too far and drive off the front of them.

    Also, watch out for the cheap metal ramps. They hold the front up fine, but the ones I have used have a tendency to slide out from under the wheels when you are trying to get up them. I have a set of plastic ones now that have a rubber piece that sticks out that the wheels hit first and they have never tried to skid out on me.

  2. Mark
    Mark says:

    I’ve always been told to fill the new oil filter about 3/4 of the way up with new oil before screwing it back on. Do you recommend this or is it not necessary?

    • Charles
      Charles says:

      That is a really great question. The answer is, “it depends”. I don’t generally do it on VWs.

      I only do that when the filter is vertical. That is more likely to starve for oil, for a longer period of time. I think this is a big deal on bigger engines, like trucks.

      Our parts delivery truck has a filter that holds over a quart of oil, AND it’s vertical. If I change the oil on that, I pre-fill it.

      It is not a bad habit at all.

  3. Jon@Auto Mechanic
    Jon@Auto Mechanic says:

    You know, I really agree with your post. My bad when oil change is that I usually in a hurry which is supposed to be very wrong and I know that. I think the reason why I am like that is I know exactly how to do it that is why I always make it fast. Again, that is wrong and will take of note that.


Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply to Pat ~ The Muscle Car Guy Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.